Intamsys FUNMAT PRO 310 - Supply Filament after Out-Of-Material Warning; Basic Printing Operations; Prepare Printer

58
5.3.4 Supply filament after out-of-material warning
The printer provides the out-of-material alarm function. When the material runs out, the printer will
pause while an alarm code prompting you to change the material will pop up on the screen. Click
the "Supply filament" button on the screen, and then change the material according to the prompts
on the screen. The procedure is as follows:
1. Unload the old material.
2. Load the new material.
3. After the material is loaded, click the "Print" button on the screen to continue printing.
Fig. 5.10 Out-of-material Warning Interface
5.4 Basic Printing Operations
5.4.1 Prepare printer
Prepare the printer for prototyping:
1. Power on the printer (see 5.1.1 for details);
2. Use a extruder brush to remove materials left on the extruder;
3. Clean the residues or impurities on the printing build plate and magnetic platform base
plate;
4. Place the printing build plate on the platform base plate along the left and right guide
grooves of the magnetic platform base plate;
Note: The magnetic platform base plate has a large suction force. When placing, hold the printing
platform handle tightly with both hands, tilt the printing build plate, let it to contact the magnetic
base plate on the rear side first, and then slowly lay it on the platform by magnetic attraction to
avoid hand pinching.