Section C - Electrics
Alternator
Dismantling and Assembling
C - 48 C - 48
9803-9450-1
Check the rotor poles and the inner faces of the stator for
signs of rubbing, which indicates worn bearings. The drive
end bearing is part of bracket 17 and cannot be removed
separately. If requiring renewal, needle roller bearing 20
should be pressed out in the direction of the arrow.
Assembling
Reverse the dismantling procedure, but note the following:
Ensure that spacers 14, 16 and 18 are correctly positioned
as shown.
Ensure that the slip rings J are clean and smooth, using
extra fine glass paper to rectify slight imperfections.
Ensure that insulation bushes 9 and washer 5 are
positioned as shown.
Take care not to damage the brushes when fitting the
brush box and regulator assembly.
Table 5. Torque Settings
Item Nm kgf m lbf ft
3 2.70.282.0
5 4.10.413.0
6 3.40.352.5
7 5.40.554.0
12 60.0 6.10 44.2
To Next Page
Loading...
