Section J - Tracks
Idler Wheels and Rollers
Guide Roller
J - 22 J - 22
9803-9450-1
Guide Roller
Removal
These components can be removed without removing the
track frame from the machine.
Fig 30.
1 Remove track (see K
Removal ( T J-15)).
2 Remove securing bolts from each side of roller
assembly D.
3 Knock roller assembly D out of track frame.
Replacement
Replacement is a reversal of the removal procedure.
When replacing, align the flat on the roller assembly with
the bottom of the track frame.
Note: It may be necessary to open out the track frame,
using a suitable jack, to allow the roller to slide into
position.
Apply JCB Threadlocker & Sealer to threads of securing
bolts and tighten to 220 Nm (162 lbf ft; 22 kgf m).
D
To Next Page
Loading...
