jcb Robot 160 - Fluids, Lubricants and Capacities; Coolant Mixtures

Section 3 - Maintenance
Routine Maintenance
Fluids, Lubricants and Capacities
3 - 12 3 - 12
9803/9450-1
Fluids, Lubricants and Capacities
Coolant Mixtures
T3-009_3
Check the strength of the coolant mixture at least once a
year, preferably at the start of the cold period.
Replace the coolant mixture according to the intervals
shown in the machine's Service Schedule.
!MWARNING
Antifreeze can be harmful. Obey the manufacturer's
instructions when handling full strength or diluted
antifreeze.
7-3-4-4_1
You must dilute full strength antifreeze with clean water
before use. Use clean water of no more than a moderate
hardness (pH value 8.5). If this cannot be obtained, use
de-ionized water. For further information advice on water
hardness, contact your local water authority.
The correct concentration of antifreeze protects the engine
against frost damage in winter and provides year round
protection against corrosion.
The protection provided by JCB High Performance
Antifreeze and Inhibitor is shown below.
Important: Do not exceed a 60% concentration, as the
freezing protection provided reduces beyond this point.
If you use any other brand of antifreeze:
ITEM
CAPACITY
Litres (Gal) FLUID/LUBRICANT
INTERNATIONAL
SPECIFICATION
Engine (Oil) 8.4 (1.8) JCB Engine Oil EP 15W/40 SAE15W/40, ACEA E5/B3/A3,
API CH-4/SG
Hydraulic System 30 (6.6) JCB High Performance 10W/30 ACEA E2:B2:A2, API CF-4/SG
JCB High Performance 15W/40 ACEA E2:B2:A2, API CF-4/SG
(top up only)
Cooling System JCB High Performance Antifreeze and
Inhibitor/Water. K
Coolant
Mixtures ( T 3-12)
ASTM D6210
- Total Coolant 8 (1.8)
- Antifreeze 4 (0.9)
Fuel Tank 80 (17.6) Diesel Oil. K
Types of Fuel ( T 3-40)
Grease Points JCB Special HP Grease Lithium complex NLGI No.2
consistency including extreme
pressure additives.
or JCB Special MPL-EPGrease Lithium based NLGI No. 2
consistency including extreme
pressure additives.
Chain Case 17 (3.8) Engine oil
50% Concentration (Standard)
Protects against damage down to -40 °C (-39 °F)
60% Concentration (Extreme Conditions Only)
Protects against damage down to -56 °C (-68 °F)