Section F - Transmission
Drive Chains
Removal and Replacement
F - 14 F - 14
9803-9460-1
Fig 11.
Starting with the rear chain, remove bolt D, washer E and
preload washer F then withdraw sprocket G from shaft H.
Release the chain from the motor drive sprocket then lift
out sprocket G and chain from the chaincase.
Repeat for the front chain.
Replacement
Replacement is the reverse of the removal sequence.
After fitting sprocket G make sure that preload washer F is
fitted with the stepped face towards the sprocket. Tighten
bolt D to 220 Nm (162 lbf ft, 22.4 kgf m).
Refit the right hand wheel hub assembly
K
Replacement ( T F-5).
Adjust the chains K
Adjustment ( T F-15).
Refit the chaincase access cover using a new gasket.
Refill the chaincase with the correct oil (see Fluids,
Lubricants and Capacities).
G
D
E
F
H
To Next Page
Loading...
