jcb Robot 160 - Safety Decals; Safety Checklist

Section 2 - Care & Safety
Safety Check List
Safety Decals
2 - 13 2 - 13
9803-9450-1
Safety Decals
Fig 1.
!MWARNING
Decals
Decals on the machine warn you of particular hazards.
You can be injured if you do not obey the decal safety
instructions.
Each decal is attached close to a part of the machine
where there is a possible hazard. Make sure
replacement parts include warning decals where
necessary.
Keep all decals clean and readable. Replace lost or
damaged decals. Each decal has a part number
printed on it, use this number to order a new decal
from your JCB distributor.
INT-3-3-3_1
!MWARNING
If you need eye-glasses for reading, make sure you
wear them when reading the safety decals. Decals are
strategically placed around the machine to remind you
of possible hazards. Do not over-stretch or place
yourself in dangerous positions to read the decals.
INT-3-3-4_1
WARNING
BEWARE OF FAN
SWITCH OFF ENGINE
817/03150
PARK BRAKE
THE PARK BRAKE IS APPLIED
AUTOMATICALLY WHEN THE
DRIVER RESTRAINT IS RAISED
AUTOMATICALLY RELEASE WHEN THE
RESTRAINT IS LOWERED. IF IT
HAS NOT RELEASED DRIVE THE MACHINE
SLIGHTLY BACKWARDS AND FORWARDS
THE PARK BRAKE WILL NORMALLY
UPWARDS
817/16643
WARNING
DO NOT OPERATE OR WORK ON THIS MACHINE
UNLESS YOU HAVE READ AND UNDERSTAND THE
INSTRUCTIONS AND WARNINGS IN THE OPERATION
AND MAINTENANCE MANUAL. FAILURE TO FOLLOW
THE INSTRUCTIONS OR HEED WARNINGS
COULD RESULT IN INJURY OR DEATH.
CONTACT ANY JCB DEALER FOR REPLACEMENT
COPIES. PROPER CARE IS YOUR RESPONSIBILITY
817/01639
IMPORTANT
INSTALLING THE SAFETY STRUT
1. EMPTY THE SHOVEL OR ATTACHMENT AND RAISE
2. STOP THE ENGINE.
3. REMOVE THE STRUT FROM ITS STOWAGE POSITION
4. START THE ENGINE.
5. SLOWLY LOWER THE ARM ONTO THE SAFETY STRUT.
STOP LOWERING IMMEDIATLEY THE WEIGHT OF THE
ARM IS SUPPORTED BY THE STRUT
LOADER ARM ENOUGH TO FIT THE SAFETY STRUT.
REMOVING THE SAFETY STRUT
1. MAKE SURE THAT THE DRIVE LEVER IS IN THE
2. RAISE THE LOADER ARM TO TAKE THE WEIGHT.
OFF THE SAFETY STRUT.
3. STOP THE ENGINE.
4. REMOVE THE STRUT:
RELEASE THE SECURING STRAP.
REMOVE THE SAFETY STRUT FROM THE LIFT RAM.
RETURN THE SAFETY STRUT TO ITS
STOWAGE POSITION.
NEUTRAL (REST) POSITION.
817/03775
817/03775
817/16643
817/04330
817/03150
817/01639