Section 3 - Maintenance
Routine Maintenance
Greasing
3 - 22 3 - 22
9803/9450-1
Every 50 Hours
!MWARNING
Never walk or work under raised equipment unless it
is supported by a mechanical device. Equipment
which is supported only by a hydraulic device can
drop and injure you if the hydraulic system fails or if
the control is operated (even with the engine stopped).
13-2-3-7
Loader Arm Pivot Point
Switch off the engine and ensure it cannot be started while
you are doing this job.
Total of 2 grease points A (one each end of pin)
Lift Ram Pivots
Total of 2 grease points B
Fig 5.
A
B
B
To Next Page
Loading...
