Section E - Hydraulics
Drive Motors
Motors - Wheeled Machine
E - 85 E - 85
9803-9450-2
Dismantling
Note: The lower motor bearing housing is shown on the
right hand side of the following illustrations. The upper
housing is shown on the left hand side.
Fig 73.
1 Remove the four motor mounting capscrews A and
separate the motor B from the bearing housing.
Discard ‘O’ ring C.
Important: Do not pick up the motor by the drive shaft as
this can cause damage to the balance plate inside the
motor.
2 Remove the spacer D from inside the drive spline
bore and set aside for reassembly.
A
A
B
C
D
To Next Page
Loading...
