Section F - Transmission
Wheel Hubs and Drive Shafts
Wheel Hub Assembly (right hand)
F - 9 F - 9
9803-9450-1
Fig 6.
Position a dial gauge against the flat face of the sprocket
as shown at D and zero the gauge. Reposition the dial
gauge onto the end of the axle shaft as shown at E and
note the reading. Remove the gauge and assembly tool.
Preload washer 3 is available in various thicknesses to
allow for the correct preload of bearings 6 and 7 as follows:
Select the preload washer which gives the closest match
to the dial gauge reading.
Assemble the preload washer 3 onto the axle shaft with the
stepped face towards the shaft (part numbered face away
from the shaft). Fit washer 2 and bolt 1. Progressively
tighten bolt 1 to 220 Nm (162 lbf ft, 22.4 kgf m) whilst
rotating the shaft to seat the bearings.
Check that the hub rotates freely by hand.
Table 1. Torque Settings
Part No. Thickness
242/00096 0.025 - 0.045 mm
823/10303 0.05 - 0.11 mm
823/10304 0.115 - 0.175 mm
823/10254 0.18 - 0.24 mm
823/10255 0.245 - 0.305 mm
823/10256 0.31 - 0.37 mm
823/10257 0.375 - 0.435 mm
823/10258 0.44 - 0.50 mm
823/10259 0.505 - 0.565 mm
823/10317 0.57 - 0.63 mm
D
E
C
Item Nm kgf m lbf ft
C
(1)
(1) Torque setting whilst checking Preload
80 59 8.2
1 220 162 22.4
9 28 21 3
To Next Page
Loading...
