Section 3 - Maintenance
Routine Maintenance
Engine
3 - 35 3 - 35
9803/9450-1
Fig 19.
8 Unscrew the filter canister E, using a chain wrench if
necessary. Remember that it will contain some oil.
9 Clean filter head F.
10 Add clean engine oil to the new filter canister. Allow
time for the oil to pass through the filter element.
11 Smear the seal G on the new filter canister E with
clean engine oil.
12 Screw in the new filter canister - hand tight only.
13 Fill the engine with the recommended oil, to the MAX
mark on the dipstick A, through the filler point B,
K
Fluids, Lubricants and Capacities ( T 3-12).
Wipe off any spilt oil, refit the filler cap and make sure
it is secure.
14 Make sure the engine will not start by removing the
engine shut-off solenoid (ESOS) fuse, K
Fuses and
Relays ( T 3-28). Turn the engine using the starter
key until the oil pressure warning light is extinguished.
15 Refit the engine shut-off solenoid fuse and start the
engine. Check for leaks. When the engine has
cooled, check the oil level and, if necessary, top up
with clean engine oil.
16 Close and lock the engine compartment top cover.
Note: Old engine oil and filters should be disposed of in
accordance with local Health and Safety regulations.
E
F
G
To Next Page
Loading...
