Juniper SRX Series User Manual

8-Port Gigabit Ethernet SFP XPIM Key Features
The 8-Port Gigabit Ethernet small form-factor pluggable XPIM (SFP XPIM) has the
following key features:
•
8 triple-speed (10/100/1000 Mbps) Ethernet ports, double-high card
•
PoE not supported
•
PCI-Express interface for control and management
•
I2C interface for module monitor and identification
•
Maximum module power of 40.0 W without PoE
•
JTAG support for boundary scan test
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
Related
Documentation
8-Port Gigabit Ethernet SFP XPIM Overview on page 91•
• 8-Port Gigabit Ethernet SFP XPIM Hardware Specifications on page 93
• 8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications on page 25
• 8-Port Gigabit Ethernet SFP XPIM Supported Modules on page 95
• 8-Port Gigabit Ethernet SFP XPIM LEDs on page 94
• 8-Port Gigabit Ethernet SFP XPIM Components on page 92
• 8-Port Gigabit Ethernet SFP XPIM Basic Configuration on page 227
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications
Table 50 on page 93 gives the physical specifications of the 8-Port Gigabit Ethernet small
form-factor pluggable XPIM (SFP XPIM).
Table 50: 8-Port Gigabit Ethernet SFP XPIM Physical Specifications
ValueDescription
0.78 in. x 6.72 in. x 8.1 in.
(1.98 cm x 17.1 cm x 20.57 cm)
Dimensions (H x W x L)
17.6 oz (0.499 kg)Weight
93Copyright © 2015, Juniper Networks, Inc.
Chapter 13: 8-Port Gigabit Ethernet SFP XPIM

Juniper SRX Series Specifications

General

Brand	Juniper
Model	SRX Series
Category	Gateway
Language	English