CHAPTER 25
Configuring Mini-Physical Interface
Modules
•
1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Basic
Configuration on page 205
•
1-Port SFP Mini-Physical Interface Module Basic Configuration on page 208
•
1-Port ADSL2+ Mini-Physical Interface Module Basic Configuration on page 209
•
1-Port DOCSIS Mini-Physical Interface Module Basic Configuration on page 211
•
1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Basic Configuration on page 213
•
1-Port Serial Mini-Physical Interface Module Basic Configuration on page 214
•
1-Port T1/E1 Mini-Physical Interface Module Basic Configuration on page 215
•
1-Port VDSL2 (Annex A) Mini-Physical Interface Module Basic Configuration on page 217
1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Basic Configuration
To enable the 1-Port Gigabit Ethernet small form-factor pluggable Mini-Physical Interface
Module (SFP Mini-PIM) installed on the SRX Series Services Gateway, you must configure
the basic settings for the PIM. You can perform the configuration tasks for this using
either the J-Web interface or the CLI.
•
Using the J-Web Interface on page 205
•
Using the CLI on page 206
Using the J-Web Interface
To perform basic configuration of the 1-Port Gigabit Ethernet SFP Mini-PIM and to
configure network interfaces for the services gateway using the J-Web interface:
1. In the J-Web interface, select Configure>Interfaces>Ports.
The Interfaces page is displayed and lists the network interfaces present on the services
gateway, along with configuration information (if the device is configured).
2. To configure properties for a network interface (Mini-PIM), select the interface name,
and click Edit.
205Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
