Juniper SRX Series

CHAPTER 24
Serial Gigabit-Backplane Physical
Interface Module Cable Specifications
•
8-Port Serial GPIM Interface Cables on page 161
•
EIA-449 DCE Cable Pinouts for 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 163
•
EIA-449 DTE Cable Pinouts for 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 168
•
EIA-530 DCE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 171
•
EIA-530 DTE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 175
•
EIA-530A DCE Cable Pinouts for 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 179
•
EIA-530A DTE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 183
•
RS-232 DCE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 186
•
RS-232 DTE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 188
•
V.35 DCE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 190
•
V.35 DTE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 194
•
X.21 DCE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 197
•
X.21 DTE Cable Pinouts for the 8-Port Serial Gigabit-Backplane Physical Interface
Module on page 199
8-Port Serial GPIM Interface Cables
All the ports of the 8-Port Serial Gigabit-Backplane Physical Interface Module (GPIM)
are connected to two dual stacked 136-pin VHDCI connectors. Custom cables are used
to connect from the VHDCI connectors to the data terminal equipment (DTE) or the data
161Copyright © 2015, Juniper Networks, Inc.