Juniper SRX Series

1-Port Serial Mini-Physical Interface Module Key Features
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) provides the following key
features:
•
Autoselection of operational modes based on DTE or DCE cables
•
Local and remote loopback diagnostics
•
Configurable clock rate for the transmit (TX) clock and receive (RX) clock
•
Complete configuration and management by using the CLI and the J-Web interface
Related
Documentation
1-Port Serial Mini-Physical Interface Module Overview on page 61•
• 1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 62
• 1-Port Serial Mini-Physical Interface Module Supported Standards on page 63
• MTU Default and Maximum Values for Physical Interface Modules on page 12
• 1-Port Serial Mini-Physical Interface Module LEDs on page 63
• 1-Port Serial Mini-Physical Interface Module Basic Configuration on page 214
1-Port Serial Mini-Physical Interface Module Hardware Specifications
Table 35 on page 62 gives the physical specifications of the 1-Port Serial Mini-Physical
Interface Module (Mini-PIM).
Table 35: 1-Port Serial Mini-PIM Physical Specifications
ValueDescription
0.8 in. x 3.75 in. x 5.9 in.
(2.0 cm x 9.5 cm x 14.5 cm)
Dimensions (H x W x L)
3.04 oz (86 g)Weight
60-pin Synchronous Serial (female)Connector type
Mini-PIMForm factor
Related
Documentation
1-Port Serial Mini-Physical Interface Module Overview on page 61•
• 1-Port Serial Mini-Physical Interface Module Supported Standards on page 63
• 1-Port Serial Mini-Physical Interface Module Key Features on page 62
• 1-Port Serial Mini-Physical Interface Module LEDs on page 63
• 1-Port Serial Mini-Physical Interface Module Basic Configuration on page 214
Copyright © 2015, Juniper Networks, Inc.62
SRX Series Services Gateways for the Branch Physical Interface Modules Reference