CHAPTER 28
Overview of Replacing Interface Modules
•
Required Tools and Parts for Replacing a Mini-Physical Interface Module on page 245
•
Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface
Module on page 245
•
Preventing Electrostatic Discharge Damage to the SRX Series Services
Gateway on page 246
Required Tools and Parts for Replacing a Mini-Physical Interface Module
The following tools and parts are required for replacing Mini-Physical Interface Modules
(Mini-PIMs) on the SRX Series Services Gateway:
•
Electrostatic bag or antistatic mat, for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat blade (–) screwdriver, approximately 1/8 in. (3 mm)
•
Phillips (+) screwdriver, number 1
Related
Documentation
Removing a Blank Mini-Physical Interface Module Faceplate from the SRX Series
Services Gateway on page 249
•
• Installing a Mini-Physical Interface Module in the SRX Series Services Gateway on
page 250
• Removing a Mini-Physical Interface Module from the SRX Series Services Gateway on
page 252
• SRX Series Services Gateway Mini-Physical Interface Modules Overview on page 7
Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module
The following tools and parts are required for replacing a Gigabit-Backplane Physical
Interface Module (GPIM) on the SRX Series Services Gateway:
•
Electrostatic bag or antistatic mat, for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade (–) screwdriver, approximately 1/8 in. (3 mm)
245Copyright © 2015, Juniper Networks, Inc.
To Next Page
