Juniper SRX Series

Table 56: 16-Port Gigabit Ethernet XPIM Components (continued)
DescriptionLocationComponent
NOTE: Each port on the
16-Port Gigabit Ethernet with
PoE XPIM supports Power over
Ethernet (PoE).
Each Gigabit Ethernet port:
•
Provides link speeds of
10/100/1000 Mbps
•
Uses an RJ-45 connector
•
Operates in full-duplex and
half-duplex modes
•
Supports flow control
•
Supports autonegotiation
Middle of the XPIM16 fixed Gigabit Ethernet ports
labeled 0 to 15
NOTE: The 16-Port Gigabit
Ethernet with PoE XPIM port
labels are yellow instead of
white.
Use the captive screws to hold
the XPIM in place in the
services gateway.
One on each side of the XPIMCaptive screws
Use the handles to grasp the
XPIM for installation or
removal.
One on each side of the XPIMHandles
Related
Documentation
16-Port Gigabit Ethernet XPIM Overview on page 103•
• 16-Port Gigabit Ethernet XPIM Key Features on page 105
• 16-Port Gigabit Ethernet XPIM Hardware Specifications on page 106
• 16-Port Gigabit Ethernet XPIM LEDs on page 106
• 16-Port Gigabit Ethernet XPIM Basic Configuration
• Power over Ethernet Support on SRX Series Services Gateway Interfaces on page 16
16-Port Gigabit Ethernet XPIM Key Features
The 16-Port Gigabit Ethernet XPIM has the following key features:
•
16 triple-speed (10/100/1000 Mbps) Ethernet ports, double-high card
•
PoE support for all ports
•
PCI-Express interface for control and management
•
I2C interface for module monitor and identification
•
Maximum module power of 40.0 W without PoE
•
JTAG support for boundary scan test
105Copyright © 2015, Juniper Networks, Inc.
Chapter 15: 16-Port Gigabit Ethernet XPIM