To Next Page

To Previous Page

• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Key Features on page 58

• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Hardware Specifications on

page 59

1-Port Serial Mini-Physical Interface Module Basic Configuration

To enable the 1-Port Serial Mini-Physical Interface Module (Mini-PIM) installed on the

SRX Series Services Gateway, you must configure the basic settings for the PIM. You can

perform the configuration tasks for this using either the J-Web interface or the CLI.

•

Using the J-Web Interface on page 214

•

Using the CLI on page 215

Using the J-Web Interface

To perform basic configuration of the 1-Port Serial Mini-PIM and to configure network

interfaces for the services gateway using the J-Web interface:

1. In the J-Web interface, select Configure>Interfaces>Ports.

The Interfaces page displays and lists the network interfaces present on the services

gateway, along with configuration information (if configured).

2. To configure properties for a network interface (Mini-PIM), select the interface name

(se-1/0/0), and click Edit.

3. To use the port on the Mini-PIM, you must assign it to a security zone other than the

Null zone. Optionally, you can also assign the port an IP address (for example,

192.168.3.1/24). Enter or select the following settings:

a. Select Configure>Security>Zones.

b. Add or select a security zone other than Null; for example, Trust

c. For host inbound traffic, set the following:

•

System Services=Allow All

•

Protocols=Allow All

d. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

4. To use the port on the Mini-PIM, you must also set security policies. Select the following

settings:

a. Select Configure>Security>Policy>Apply Policy.

b. Set Policy Action: Default Policy Action=Permit-All.

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

SRX Series Services Gateways for the Branch Physical Interface Modules Reference

Juniper SRX Series User Manual

Other manuals for Juniper SRX Series