Juniper SRX Series

Table 20: 8-Port Serial GPIM Network Interface Specifications (continued)
SpecificationDescription
•
data terminal equipment (DTE)
•
clear to send (CTS)
•
data carrier detect (DCD)
•
data set ready (DSR)
•
data circuit-terminating equipment (DCE)
•
request to send (RTS)
•
data terminal ready (DTR)
Modes
Up to 8 MbpsSynchronous Tx/Rx rate/port
rx_error_counts, tx_abort_counts, rx_giant_counts,
rx_runt_counts, and crc_err_counts
Error counters
HDLC Features
56K or 64KMode
SupportedPPP, Frame Relay, and Cisco-HDLC
protocols
SupportedShared flag
SupportedIdle flag/fill (0x7e or all ones)
Runts, giants, fcs error, abort error, and align errorCounters
Related
Documentation
8-Port Serial GPIM Overview on page 97•
• 8-Port Serial GPIM Hardware Specifications on page 99
• 8-Port Serial GPIM Components on page 98
• 8-Port Serial GPIM Key Features on page 99
• 8-Port Serial GPIM LEDs on page 100
• 8-Port Serial GPIM Interface Cables on page 161
• 8-Port Serial GPIM Basic Configuration on page 230
Dual CT1/E1 GPIM Network Interface Specifications
The Dual CT1/E1 Gigabit-Backplane Physical Interface Module (GPIM) provides the
network interface specifications specific to T1 or E1 modes, listed in Table 21 on page 28.
27Copyright © 2015, Juniper Networks, Inc.
Chapter 2: Network Interface Specifications