Juniper SRX Series User Manual

1-Port SFP Mini-Physical Interface Module Key Features
The 1-Port small form-factor pluggable Mini-Physical Interface Module (SFP Mini-PIM)
has the following key features:
•
Enables you to install and remove transceivers without powering down the device
•
Provides real-time visual status of connectivity and traffic flows
•
Provides Link Up/Down alarm
•
Supports the following transceiver types:
•
1000BASE-SX
•
100BASE-LX
•
1000BASE-LX10
•
100BASE-FX
•
1000BASE-T
•
1000BASE-LH (ZX)
•
Tri-Rate 10/100/1000BASE-T, Copper Transceiver
•
1000BASE-BX10, at 10 km (TX1310 nm / RX1490 nm)
•
1000BASE-BX10, at 10 km (TX1310 nm / RX1550 nm)
•
1000BASE-BX10, at 10 km (TX1490 nm / RX1310 nm)
•
1000BASE-BX10, at 10 km (TX1550 nm / RX1310 nm)
•
1000BASE-BX, at 40 km (TX1310 nm / 1550 nm)
•
1000BASE-BX, at 40km (TX1550 LC nm / RX1310 nm)
•
100Base-BX Fast Ethernet Optics, at 20 km (TX 1310 nm / RX 1550 nm)
•
100Base-BX Fast Ethernet Optics, at 20 km (TX 1550 nm / RX 1310 nm)
NOTE: The 1-Port SFP Mini-PIM with Ethernet connector provides 1000-Mbps
link speed. Actual bandwidth is limited to 100 Mbps.
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
Copyright © 2015, Juniper Networks, Inc.40
SRX Series Services Gateways for the Branch Physical Interface Modules Reference

Juniper SRX Series Specifications

General

Category	Gateway
Operating System	Junos OS
Product Family	SRX Series
Purpose	Security
VPN Throughput	Varies greatly depending on the specific model, ranging from Gbps to Tbps
Power Supply	Varies depending on the specific model (e.g., AC, DC, Redundant)