set interfaces at-1/0/0 unit 0 family inet address interface address/destination prefix
•
Add or select a security zone; for example, Trust:
set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic
system-services all
•
Add or select security zones for host inbound traffic protocol options:
set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic protocols
all
•
Set security policies:
set security policies default-policy permit-all
See the Junos OS Network Interfaces Configuration Guide for more details.
Related
Documentation
1-Port ADSL2+ Mini-Physical Interface Module Overview on page 45•
• 1-Port ADSL2+ Mini-Physical Interface Module Hardware Specifications on page 47
• 1-Port ADSL2+ Mini-Physical Interface Module Network Interface Specifications on
page 21
• 1-Port ADSL2+ Mini-Physical Interface Module Supported Standards on page 48
• 1-Port ADSL2+ Mini-Physical Interface Module Key Features on page 46
• 1-Port ADSL2+ Mini-Physical Interface Module LEDs on page 47
1-Port DOCSIS Mini-Physical Interface Module Basic Configuration
To enable the Data over Cable System Interface Specifications Mini-Physical Interface
Module (1-Port DOCSIS Mini-PIM) installed on the SRX Series Services Gateway, you
must configure its properties. You can perform the same configuration tasks using either
the J-Web interface or the CLI:
•
Using the J-Web Interface on page 211
•
Using the CLI on page 212
Using the J-Web Interface
To perform basic configuration for the 1-Port DOCSIS Mini-PIM and to configure network
interfaces for the services gateway using the J-Web interface:
1. In the J-Web interface, selectConfigure>Interfaces>Ports .
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
2. To configure properties for a network interface (Mini-PIM), select the interface name
(cm-1/0/0), and click Edit.
211Copyright © 2015, Juniper Networks, Inc.
Chapter 25: Configuring Mini-Physical Interface Modules
To Next Page
Loading...
Need help?
General
