Juniper SRX Series

•
Verify that the 1-Port VDSL2 interface is installed on the device:
show chassis hardware
•
Verify the status of the interface:
show interfaces terse
•
Assign the port an IP address:
set interfaces pt-1/0/0 unit 0 family inet address interface address/destination prefix
•
Add or select a security zone; for example, Zone1:
set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic
system-services all
•
Add or select security zones for host inbound traffic options protocols:
set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic protocols
all
•
Set security policies:
set security policies default-policy permit-all
See the Junos OS Network Interfaces Configuration Guide for more details.
Related
Documentation
• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Overview on page 71
• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Key Features on page 72
• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Supported Profiles on page 74
• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Hardware Specifications on
page 72
• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Cable Specifications on page 141
219Copyright © 2015, Juniper Networks, Inc.
Chapter 25: Configuring Mini-Physical Interface Modules