Juniper SRX Series

Fragment frames 0
VLAN tagged frames 0
Code violations 0
Filter statistics:
Input packet count 0
Input packet rejects 0
Input DA rejects 0
Input SA rejects 0
Output packet count 0
Output packet pad count 0
Output packet error count 0
CAM destination filters: 1, CAM source filters: 0
Autonegotiation information:
Negotiation status: Complete
Link partner:
Link mode: Full-duplex, Flow control: None, Remote fault: OK,
Link partner Speed: 1000 Mbps
Local resolution:
Flow control: None, Remote fault: Link OK
Packet Forwarding Engine configuration:
Destination slot: 3
CoS information:
Direction : Output
CoS transmit queue Bandwidth Buffer Priority
Limit
% bps % usec
0 best-effort 95 950000000 95 0 low
none
3 network-control 5 50000000 5 0 low
none
Interface transmit statistics: Disabled
4. Assign the interface an IP address:
[edit]
user@host# set interfaces interface-name unit 0 family inet address interface
address/destination prefix
5. Set security policies:
[edit]
user@host# set security policies policy-name
Related
Documentation
8-Port Gigabit Ethernet SFP XPIM Overview on page 91•
• 8-Port Gigabit Ethernet SFP XPIM Hardware Specifications on page 93
• 8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications on page 25
• 8-Port Gigabit Ethernet SFP XPIM Supported Modules on page 95
• 8-Port Gigabit Ethernet SFP XPIM Key Features on page 93
• 8-Port Gigabit Ethernet SFP XPIM LEDs on page 94
• 8-Port Gigabit Ethernet SFP XPIM Components on page 92
229Copyright © 2015, Juniper Networks, Inc.
Chapter 26: Configuring Gigabit-Backplane Physical Interface Modules