Keba KeDrive D3-DU 3 A Series - Directives, Standards and Regulations; EU Directives; Standards for Checking the Conformity

D3-DU 3xx/A, /BDirectives, standards and regulations
Project engineering manual V1.09
120
© KEBA 2021
13 Directives, standards and regulations
13.1 EU Directives
Richtlinie 2014/30/EU EMC Directive
Richtlinie 2011/65/EU RoHS Directive
The following directive is valid for the D3-DU 3x5/x:
Functional safety
Richtlinie 2006/42/EG Machinery Directive
13.2 Standards for checking the conformity
The following legally non-binding European standards were applied to
checking conformity with the directives.
Check of the conformity with the EMC Directive
EN 61131-2:2007
Programmable controllers - Part 2: Equipment require-
ments and tests
*)
EN IEC 61800-3:2018
Adjustable speed electrical power drive systems - Part
3: EMC requirements and specific test methods
EN IEC 61000-6-2:2019
In preparation
Electromagnetic compatibility (EMC) - Part 6-2:
Generic standards - Immunity standard for industrial
environments
EN IEC 61000-6-4:2019
In preparation
Electromagnetic compatibility (EMC) - Part 6-4:
Generic standards - Emission standard for industrial
environments
*)
Even with voltage interruptions of ≤ 10 ms, the device can go into an alarm
state!
The following functional safety standards are applicable to the D3-DU 3x5/x:
Functional safety
EN 61131-6:2012 Programmable controllers - Part 6: Functional safety
EN 61000-6-7:2015
Electromagnetic compatibility (EMC) - Part 6-7:
Generic standards - Immunity requirements for equip-
ment intended to perform functions in a safety-related
system (functional safety) in industrial locations
EN 61326-3-1:2017
Electrical equipment for measurement, control and
laboratory use - EMC requirements - Part 3-1: Immu-
nity requirements for safety-related systems and for
equipment intended to perform safety-related functions
(functional safety) - General industrial applications