D3-DU 3xx/A, /BIntroduction
Project engineering manual V1.09
14
© KEBA 2021
● Correct and complete installation of all components in compliance with
the specified conditions.
● Correct and complete wiring of all components
● Creation of a complete safety application
● Verification and validation of all safety functions
● Compliance of requirements of Machinery Directive and if necessary lo-
cal laws for a complete machine
1.4 Notes on this document
This manual is an integral part of the product. It is to be retained over the en-
tire life cycle of the product and should be forwarded to any subsequent
owners or users of the product. For end users, necessary safety notes and
information must be integrated in the instruction manual for end users in the
specific national language by the mechanical engineer or the system
provider.
This documentation must be legible and available to the specified persons
and must be read and understood by them.
The manual corresponds to the current state of knowledge at the time of
publication. Due to further technical developments, it is subject to changes in
content. So it is recommended to check with KEBA regularly (e.g. via web-
side), if an updated manual version suitable to the product is available.
Information
This manual also applies to the customer variants that are identical in con-
struction and function.
Because these types of customer variants occasionally differ from the
KEBA standard variant in their appearance (e.g. due to a different front
membrane), the devices pictured in this manual may differ in appearance
from the devices you are using.
This document refers to the following version of safety control:
HW-Version: 07-05
FW-Version:
● 2.0.0.2L
● 2.0.0.3
● 2.0.0.9
● 2.1.100
● 3.0.0
To Next Page
Loading...
Need help?
General
