Keba KeDrive D3-DU 3 A Series - Conformity of Safety Fieldbusses; Ethercat Declaration

D3-DU 3xx/A, /BIntroduction
Project engineering manual V1.09
16
© KEBA 2021
Doc.No. Name Target group
DE: 1008535
EN: 1008536
KEBA - Functional safety
safety manual
● Safety engineer for "functional
safety"
● Project engineer
● Electrician
● Programmer
● Commissioning foreman
● Service technician
Onlinehelp
SafeEdit operating instruc-
tions
● Safety engineer for "functional
safety"
● Project engineer
● (Electrician)
● Programmer
● Commissioning foreman
● Service technician
1.6 Conformity of safety fieldbusses
The safety firmware of the KEBA safety control contains so-called "safety
stacks" (for FSoE, ProfiSafe), which are installed together with the underly-
ing functional stacks (for EtherCat, ProfiNet) of the original KEBA control
packages and which have been tested and certified for their conformity with
the applicable communication standards.
If the original bus stacks of the KEBA control package are not to be used for
functional fieldbus communication, the alternatively used bus stacks must
also have passed a conformance test of the respective responsible user or-
ganizations (ETG, PNO). This is the responsibility of the integrating party
(OEM).
In the absence of functional fieldbus conformity, the respective "safety stack"
is also excluded from all certificates and must not be used as a safe commu-
nication system.
1.6.1 EtherCAT declaration
EtherCAT® is registered trademark and
patented technology, licensed by Beckhoff
Automation GmbH, Germany.
Safety over EtherCAT® is a registered trade-
mark and patented technology, licensed by
the Beckhoff Automation GmbH, Germany.