9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
Uncalibrated Event Query" on page 1154 register when the condition register bit has
a negative transition (1 to 0).
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:INTegrity:UNCalibrated:NTRansition <integer>
:STATus:QUEStionable:INTegrity:UNCalibrated:NTRansition?
Example
:STAT:QUES:INT:UNC:NTR 1
Oversweep cleared is reported to the Integrity Summary of the Status Questionable register
Preset 0
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Questionable Integrity Uncalibrated Positive Transition
Determines which bits in the "Questionable Integrity Uncalibrated Condition" on
page 1153 register will set the corresponding bit in the "Questionable Integrity
Uncalibrated Event Query" on page 1154 register when the condition register bit has
a positive transition (0 to 1).
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:INTegrity:UNCalibrated:PTRansition <integer>
:STATus:QUEStionable:INTegrity:UNCalibrated:PTRansition?
Example
:STAT:QUES:INT:UNC:PTR 1
Oversweep set is reported to the Integrity Summary of the Status Questionable register
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
1155 IQ Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
