Keysight E6680A - Record; Record and Quick Save; Save as

3 IQ Analyzer (Basic) Mode
3.2 IQ Waveform Measurement
Example
:SPEC:REC:POINts 100
:SPEC:REC:POINts?
Dependencies In general, "Record Time" on page 409 is prioritized over Record Points. Thus, Record Points is
updated whenever Record Time or the Sample Rate is changed. The Sample Rate in the Complex
Spectrum measurement is controlled by the Span and/or Digital IF BW parameters
Preset 10000000
State Saved Yes
Min 0
Max Depends on the following items, and may differ based on the instrument that the application is
running on
–
HW memory capacity
–
IF Path
–
Sample Rate
Record
Records the data with the current measurement settings for the duration specified
using the "Record Time" on page 409 and "Record Points" on page 409 parameters.
Not available in the STReaming measurement.
Remote Command
[:SENSe]:<meas>:RECord
For <meas>, substitute SPECtrum or WAVeform
Example
:SPEC:REC
State Saved Not part of saved state
Record and Quick Save
Records the data with the current measurement settings for the duration specified
using the "Record Time" on page 409 and "Record Points" on page 409 parameters.
There is no direct SCPI corresponding to the Record and Quick Save key.
Not available in the STReaming measurement.
Save As
When this control is pressed, the view is switched to the Recording section of the
Save to File dialog view. It is essentially a short cut to the Recording section of the
Save to File dialog view.
There is no direct SCPI corresponding to the Save As key.
IQ Analyzer Mode User's &Programmer's Reference 410