Keysight E6680A - Recording; Record Time; Record Points

3 IQ Analyzer (Basic) Mode
3.2 IQ Waveform Measurement
3.2.9.3 Recording
The controls in this tab are available in the Complex Spectrum and Waveform
measurements. They are not available in the Streaming measurement.
Record Time
The duration of the recording that will occur when the "Record" on page 410 or
"Record and Quick Save" on page 410 buttons are pressed.
The unit is seconds.
Not available in the STReaming measurement.
Remote Command
[:SENSe]:<meas>:RECord:TIME <time>
[:SENSe]:<meas>:RECord:TIME?
For <meas>, substitute SPECtrum or WAVeform
Example
:SPEC:REC:TIME 4 ms
:SPEC:REC:TIME?
Dependencies In general, Record Time is prioritized over "Record Points" on page 409. However, if the Record Points
is changed directly, then Record Time is updated
Preset 1 s
State Saved Yes
Min 0
Max Depends on the following items, and may differ based on the instrument that the application is
running on
–
HW memory capacity
–
IF Path
Sample Rate
Record Points
The duration of the recording that will occur when the "Record" on page 410 or
"Record and Quick Save" on page 410 buttons are pressed.
Not available in the STReaming measurement.
Remote Command
[:SENSe]:<meas>:RECord:POINts <integer>
[:SENSe]:<meas>:RECord:POINts?
For <meas>, substitute SPECtrum or WAVeform
409 IQ Analyzer Mode User's &Programmer's Reference