3 IQ Analyzer (Basic) Mode
3.1 Complex Spectrum Measurement
Example
:DISP:SPEC:VIEW:WIND2:TRAC:X:RPOS LEFT
:DISP:SPEC:VIEW:WIND2:TRAC:X:RPOS?
Preset
LEFT
State Saved Saved in instrument state
Range
LEFT|CENTer|RIGHt
Auto Scaling
Lets you toggle the scale coupling function between ON and OFF. Only appears if the
IQ Waveform window is selected.
Remote
Command
Complex Spectrum:
:DISPlay:SPECtrum:VIEW[1]:WINDow[1]:TRACe:X[:SCALe]:COUPle 0 | 1 | OFF | ON
:DISPlay:SPECtrum:VIEW[1]:WINDow[1]:TRACe:X[:SCALe]:COUPle?
Streaming:
:DISPlay:STReaming:VIEW[1]:WINDow[1]:TRACe:X[:SCALe]:COUPle 0 | 1 | OFF | ON
:DISPlay:STReaming:VIEW[1]:WINDow[1]:TRACe:X[:SCALe]:COUPle?
Example
:DISP:SPEC:VIEW:WIND2:TRAC:X:COUP 0
:DISP:SPEC:VIEW:WIND2:TRAC:X:COUP?
Couplings When Auto Scaling is ON and the "Restart" on page 401 front-panel key is pressed, this function
automatically determines the scale per division and reference values based on the measurement results
When you set the value of either Scale/Div or Ref Value manually, Auto Scaling automatically changes
to OFF
Preset
ON
State Saved Saved in instrument state
Range
OFF|ON
3.1.9.4 Recording
The controls in this tab are available in the Complex Spectrum and Waveform
measurements. They are not available in the Streaming measurement.
Record Time
The duration of the recording that will occur when the "Record" on page 410 or
"Record and Quick Save" on page 410 buttons are pressed.
The unit is seconds.
Not available in the STReaming measurement.
279 IQ Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
