4 System
4.2 I/O Config
These commands do not apply to instruments that have only one NIC. The
commands apply to all modular deployments that have a controller with multiple
NICs.
To configure and query these configuration options, the following remote
commands are provided:
–
"Multiple Network Adapters Enabled (Remote Query Only)" on page 452
–
"Config IPV4 Address (Remote Command Only)" on page 452
–
"Config IPV6 Address (Remote Command Only)" on page 453
–
"List All Physical Network Adapter IP Addresses (Remote Query Only)" on page
453
4.2.11.1 Multiple Network Adapters Enabled (Remote Query Only)
Remote
Command
:SYSTem:COMMunicate:LAN:MULTiple:NIC:ENABled?
Example
:SYSTem:COMMunicate:LAN:MULTiple:NIC:ENABled?
Notes Applies to Instruments that have multiple Network Adapters. When more than one network adapter is
present in the system, and they are Enabled (that is, they have a valid IP Address), this query returns:
–
1, if more than one NIC enabled
–
0, if only one or No NICs are enabled
State Saved No
4.2.11.2 Config IPV4 Address (Remote Command Only)
Remote
Command
:SYSTem:COMMunicate:LAN:IPV4:CONFig <ipaddress>
:SYSTem:COMMunicate:LAN:IPV4:CONFig?
Example
:SYSTem:COMMunicate:LAN:IPV4:CONFig "192.168.1.146"
:SYSTem:COMMunicate:LAN:IPV4:CONFig?
Notes Applies to instruments that have multiple Network Adapters. When more than one network adapter is
present in the system, you must specify in the instrument config file the IP address to use to enable
Remoting channel bindings. If this is not provided, Remoting connections are likely to fail on systems
where multiple NICs are enabled
Sets the valid IPV4 address, passed in as string in the config file
The query returns IPV4 address, as a string
If config file is missing, “” (empty string) is returned
Changing the IPV4 value requires a restart of the instrument software, to ensure that servers use the
configured IP address
State Saved No
452 IQ Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
