Keysight E6680A - Marker; Select Marker

3 IQ Analyzer (Basic) Mode
3.1 Complex Spectrum Measurement
Model Input Option Value
All other models RF None 8.0 MHz
B25 25 MHz
B40 40 MHz
B85 85 MHz
B1A 125 MHz
B1X 140 MHz
B1Y 160 MHz
B2X 255 MHz
B5X 510 MHz
R10 1 GHz
R15 1.5 GHz
R20 2 GHz
R40 4 GHz
I/Q None 10.0 MHz per channel
(20.0 MHz for I+jQ)
B25 25 MHz per channel
(50 MHz for I+jQ)
S40 40MHz per channel
(80MHz for I+jQ)
3.1.7 Marker
Lets you select, set up and control the markers for the current measurement. If there
are no active markers, Marker selects Marker 1, sets its mode to POSition, and
places it at the center of the display. If the selected marker is OFF, it is set to
POSition and placed it at the center of the screen, on the trace determined by the
Marker Trace rules.
3.1.7.1 Select Marker
Lets you specify the selected marker. The term “selected marker” is used throughout
this document to specify which marker will be affected when you change marker
settings, perform a Peak Search, etc.
The Select Marker control appears above the menu panel, indicating that it applies
to all controls in the Marker menu panels. Select Marker is blanked if you select a
tab whose controls do not depend on the selected marker (e.g., Counter).
For any menu that includes Select Marker, the first control is always "Marker
Frequency" on page 204.
203 IQ Analyzer Mode User's &Programmer's Reference