4 System
4.6 Alignments
4.6.6.8 Scheduler
Setting the Scheduler to ON triggers execution of the scheduled task based on the
recurrence and time set in the scheduler since the last successful of the specific
alignment. A warning condition of “RF Preselector alignment scheduler is ON”
appears when the scheduler is set to ON. OFF prevents the Scheduler from running
any scheduled task.
Remote
Command
:CALibration:RFPSelector:SCHeduler:STATe ON | OFF | 0 | 1
:CALibration:RFPSelector:SCHeduler:STATe?
Example
:CAL:RFPS:SCH:STAT OFF
Preset Unaffected by Preset, but set to ON by Restore Defaults >"Alignments" on page 482
State Saved No
Range
OFF|ON
Schedule Setup
Lets you schedule a task to run automatically at the background based on the
recurrence and time set in the scheduler. Make sure that the instrument’s local time
is accurate, because the Scheduler relies on this information to execute the task.
This dialog contains the following controls:
–
"Task" on page 556
–
"Date/Time" on page 557
–
"Hour" on page 558
–
"Minute" on page 558
–
"Recurrence" on page 558
–
"Number of Weeks" on page 558
–
"Day" on page 559
Task
There are 3 tasks that can be selected for the scheduler to run.
–
Task 1 is the 20 Hz to 30 MHz alignment
–
Task 2 is the 30 MHz to 3.6 GHz alignment
556 IQ Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
