Keysight E6680A - Meas Preset; IF Path

3 IQ Analyzer (Basic) Mode
3.2 IQ Waveform Measurement
–
Video BANDwidth VBW/RBW ratio
–
Upper and Lower Tone (set to Sense)
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Restores all measurement parameters to their default values.
Remote Command
:CONFigure:WAVeform
Example
:CONF:WAV
Notes Restore default values of all parameters
3.2.8.2 IF Path
Lets you choose and configure the settings that control which IF path (and therefore
which IF Bandwidth) is used to process the signal.
Dependencies Only available in I/Q Analyzer Mode
IF Path
Lets you select different IF Paths for the AIF/DIF boards.
The selections are 10MHz, 25MHz, 40MHz, 85MHz,125MHz, 140MHz, 255MHz,
510MHz, 1GHz, 1.5GHz, 2GHz, 4GHz, and External. Depending on the model or
option, some of these paths might not be available.
IQ Analyzer Mode User's &Programmer's Reference 376