3 IQ Analyzer (Basic) Mode
3.1 Complex Spectrum Measurement
–
Sample Rate
Record
Records the data with the current measurement settings for the duration specified
using the "Record Time" on page 409 and "Record Points" on page 409 parameters.
Not available in the STReaming measurement.
Remote Command
[:SENSe]:<meas>:RECord
For <meas>, substitute SPECtrum or WAVeform
Example
:SPEC:REC
State Saved Not part of saved state
Record and Quick Save
Records the data with the current measurement settings for the duration specified
using the "Record Time" on page 409 and "Record Points" on page 409 parameters.
There is no direct SCPI corresponding to the Record and Quick Save key.
Not available in the STReaming measurement.
Save As
When this control is pressed, the view is switched to the Recording section of the
Save to File dialog view. It is essentially a short cut to the Recording section of the
Save to File dialog view.
There is no direct SCPI corresponding to the Save As key.
Quick Save
When this control is pressed, the data currently in the HW memory is saved to the
file with the name that was specified last with the added file number.
For instance, if the latest recording file was saved with the file name MyData.binf,
then pressing Quick Save saves the data in HW memory with the file name MyData_
0000.binf.
All subsequent Quick Save presses generate a recording file with the file number
incremented.
In the example above, it will generate the files
“MyData_0000.binf”
281 IQ Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
