3 IQ Analyzer (Basic) Mode
3.1 Complex Spectrum Measurement
Next Peak
Moves the selected marker to the peak that is next lower in amplitude than the
current marker value. Only peaks that meet all enabled peak criteria are considered.
If there is no valid peak lower than the current marker position, a “No peak found”
message is generated, and the marker is not moved.
If the selected marker was OFF, then it is turned on as a POSition marker and a
peak search is performed.
Remote Command Complex Spectrum:
:CALCulate:SPECtrum:MARKer[1]|2|…|12:MAXimum:NEXT
Streaming:
:CALCulate:STReaming:MARKer[1]|2|…|12:MAXimum:NEXT
Example
:CALC:SPEC:MARK:MAX:NEXT
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Right
Moves the selected marker to the nearest peak right of the current marker that
meets all enabled peak criteria. If there is no valid peak to the right of the current
marker position, a “No peak found” message is generated, and the marker is not
moved.
If the selected marker was OFF, then it is turned on as a POSition marker and a
peak search is performed.
Remote Command Complex Spectrum:
:CALCulate:SPECtrum:MARKer[1]|2|…|12:MAXimum:RIGHt
Streaming:
:CALCulate:STReaming:MARKer[1]|2|…|12:MAXimum:RIGHt
Example
:CALC:SPEC:MARK2:MAX:RIGH
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Left
Moves the selected marker to the nearest peak left of the current marker that meets
all enabled peak criteria. If there is no valid peak to the left of the current marker
position, a “No peak found” message is generated, and the marker is not moved.
IQ Analyzer Mode User's &Programmer's Reference 210
To Next Page
Loading...
