Table Of Contents
6.2.3 SA Frequency Extender Firmware Update (Front Panel Only) 732
6.2.4 SA Frequency Extender Cable Correction 733
6.2.5 Half Duplex Input Port 733
6.2.6 Port Information (Remote Command Only) 734
6.2.7 RF Preselector 734
6.2.8 Notch Filter 736
6.2.9 RF Calibrator 736
6.2.10 RF Coupling 737
6.2.11 Input Z Correction 739
6.2.12 All Screens Use Same Input 740
6.2.13 External Mixer Setup 740
6.2.13.1 Mixer Presets 744
6.2.13.2 Mixer Bias 749
6.2.13.3 Table Type 750
6.2.13.4 Select VDI CCD Correction 751
6.2.13.5 Delete All VDI CCD Corrections 752
6.2.13.6 Harmonic 752
6.2.13.7 LO Doubler 753
6.2.13.8 Refresh USB Mixer Connection 753
6.2.14 Mixer Path 754
6.2.15 User IF Freq 755
6.2.16 Signal ID On/Off 755
6.2.17 Signal ID Mode 756
6.2.18 Cable IF Loss 757
6.2.19 I/Q Path 758
6.2.20 Reference Z 760
6.2.21 I/Q Setup 760
6.2.21.1 I Setup 760
Differential 760
Input Z 761
Skew 762
Combined Differential/Input Z (Remote Command Only) 763
6.2.21.2 I Probe 763
Attenuation 764
Offset 765
IQ Analyzer Mode User's &Programmer's Reference 25
To Next Page
Loading...
