Keysight E6680A - Page 38

Table Of Contents
9.3.2.1 CONFigure 1076
9.3.2.2 INITiate 1077
9.3.2.3 FETCh 1077
9.3.2.4 READ 1078
9.3.2.5 MEASure 1079
9.3.3 Trace Formatting Commands 1080
9.3.3.1 Clear Trace (Remote Command Only) 1080
9.3.3.2 Send/Query Trace Data (Remote Command Only) 1081
9.3.3.3 Format Data: Numeric Data (Remote Command Only) 1083
9.3.3.4 Format Data: Byte Order (Remote Command Only) 1084
9.3.3.5 Calculate/Compress Trace Data Query (Remote Command
Only) 1084
9.3.3.6 Calculate Peaks of Trace Data (Remote Command Only) 1090
9.3.3.7 Smooth Trace Data (Remote Command Only) 1092
9.3.3.8 Number of Points for Smoothing (Remote Command Only) 1093
9.3.3.9 Mean Trace Data (Remote Command Only) 1094
9.4 Status Register System & STATus Subsystem 1095
9.4.1 Status Register System Diagram 1095
9.4.2 Status Register Hierarchy 1097
9.4.3 Status Register SCPI Commands 1099
9.4.4 How to Use Status Registers 1100
9.4.4.1 Polling Method 1100
Monitoring Options 1101
9.4.4.2 Service Request (SRQ) Method 1101
Using the Service Request (SRQ) Method 1101
9.4.5 Status Register Bit Parameters 1103
9.4.6 Status Subsystem Registers and Commands 1104
9.4.6.1 Status Byte Register 1104
Service Request Enable Register 1107
Preset the Status Byte 1107
9.4.6.2 Standard Event Status Register 1108
Standard Event Status Enable Register 1109
9.4.6.3 Operation Register 1110
Operation Condition Query 1111
Operation Enable 1112
38 IQ Analyzer Mode User's &Programmer's Reference