Keysight E6680A - Page 586

5 Preset
Type Of Preset SCPI Command Scope of Preset Front Panel
Access
Defaults" on page
591
all measurements in the Mode,
affects all parameters in the Mode,
but does not affect Input/Output or
System variables
Does not preset the RF Source.
Dropdown" on
page 588
"Restore Defaults
All Modes" on
page 598
:SYSTem:DEFault MODes
Affects all parameters in all Modes,
but does not affect Input/Output or
System variables
Presets the RF Source
"Preset
Dropdown" on
page 588
"Restore Screen
Defaults" on page
601
:SYSTem:DEFault SCReen
Deletes all Screens but one, restores
that screen to its default mode and
performs Mode Preset for that mode
Does not affect Input/Output or
System variables
Presets the RF Source
"Preset
Dropdown" on
page 588
"User Preset" on
page 594
:SYSTem:PRESet:USER
Local to the current Mode, global to
all measurements in the Mode,
affects all parameters in the Mode, as
well as Input/Output variables
Does not affect System variables
User Preset key
"Preset
Dropdown" on
page 588
"User Preset All
Modes" on page
597
:SYSTem:PRESet:USER:ALL
Same as User Preset, but affects all
Modes in the current Screen
"Preset
Dropdown" on
page 588
"User Preset All
Screens" on page
599
Affects the entire Screen
Configuration; global to all Modes
and Screens
"Preset
Dropdown" on
page 588
*RST *RST
Same as Mode Preset. Additionally
always sets Single/Cont to Single
Not available
from front panel
"Input/Output
Preset" on page
592
:SYSTem:DEFault INPut
Affects all Input/Output variables
Does not preset the RF Source
Input/Output
menu
"Preset
Dropdown" on
page 588
System > Restore
Defaults
"Full Mode
Preset" on page
593
:SYSTem:PRESet:FULL
Same as Mode Preset + Restore
Mode Defaults + Input/Output Preset.
Essentially a factory preset of the
current Mode
Presets the RF Source
"Preset
Dropdown" on
page 588
"Restore User
:SYSTem:DEFault UINTerface
Affects all variables in the ”User System > Restore
586 IQ Analyzer Mode User's &Programmer's Reference