Keysight M8195A - Page 123

Sequencing 3
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 123
3.8.1.1 Self Armed
Trigger Mode Continuous
After programming, the segment is started automatically and is repeated infinitely.
Time
Offset
Stop
(Abort)
RUN
Offset
Figure 32: Trigger mode continuous
Trigger Mode Triggered
An Offset value is provided after programming. A trigger starts the segment.
The following segment advancement modes are available:
Auto: The segment is executed the number of times specified by its loop count. Then
the last sample is played at the end.
Repeat: This advancement mode is quite the same like “Auto” with the difference that
an advancement event is required at the end.
Single: An advancement event is required for each segment repetition.
Conditional: The segment is played infinitely after receiving a trigger. After being
stopped (See SCPI command :ABORt[1|2|3|4]) the offset value is played.
RUN
Trigger
Trigger
Stop
(Abort)
Offset
Offset
Last
Value
21 3 4
1 2
Figure 33: Segment advance = auto