2G0947 - 31JAN08 3-91
Adjustments and Replacements
FILM PATH MICROCONTROLLER BOARD
Prerequisites: 1. Do “Making a Configuration Backup” on page 8-1.
2. Remove the “RIGHT PANEL”.
To Remove:
When installing CIRCUIT BOARDS, always use a WRIST STRAP to prevent
damage from electrostatic discharge.
1. Disconnect the CONNECTORS.
2. Remove:
• 3 SCREWS
• FILM PATH MICROCONTROLLER BOARD
To Install: 1. Reverse the steps in the removal procedure.
NOTE: If necessary, do “Restoring the Configuration” on page 8-2.
3 SCREWS
FILM PATH
MICROCONTROLLER
BOARD
CONNECTORS
To Next Page
Loading...
