4-12 2G0947 - 31JAN08
Preventive Maintenance
Completing the PM
1. Allow the PROCESSOR to warm to “Ready.”
2. Check the temperature of the DRUM (see Adjustments And
Replacements, “PROCESSOR - DRUM Temperature” on page 3-1).
3. If necessary, adjust the temperature.
4. Make a “Flat-field” or “Grayout” test print.
5. Compare the test print with the test print made before the PM.
6. Make a print of a customer image.
7. Check the quality of the print with the customer.
8. Leave 2 CHARCOAL FILTERS with the customer.
To Next Page
Loading...
