Kodak Dryview 5800 - Setting the System Clock

2-16 2G0947 - 31JAN08
Installation Instructions
Setting the System Clock
1. Select Configuration>System>Clock.
IMPORTANT:
The System Clock is set in the FACTORY. At installation, the Time Zone has to
be reset if the IMAGER is installed in some other Time Zone. When you reset
the Time Zone value, the Time and Date should display correctly.
2. Will the clock be set manually or does the customer use a time SERVER
for synchronization?
3. To correct the Time Zone value:
a. Click [Modify].
b. If the "Enable time synchronization" check box is selected, de-select
it.
c. Select the correct Time Zone from the drop-down menu.
d. Click [Save].
Manually Synchronization
Do Step 3- Step 15. a. Obtain the IP address of the
SERVER from the customer.
b. Do Step 16- Step 23.