Kodak Dryview 5800 - Motor, Feed Roller Nip Open;Close (M1)

2G0947 - 31JAN08 3-53
Adjustments and Replacements
MOTOR, FEED ROLLER NIP OPEN/CLOSE (M1)
Prerequisites: Remove:
• “BACK PANEL”
• “LEFT PANEL”
To Remove:
1. Disconnect the CONNECTOR.
2. Remove:
• E RING
• PULLEY
• BELT
• 4 SCREWS
• FEED ROLLER NIP OPEN/CLOSE MOTOR
To Install: 1. Reverse the steps in the removal procedure.
4 SCREWS
E RING
PULLEY
BELT
CONNECTOR
FEED ROLLER
NIP OPEN/CLOSE
MOTOR
Left Side
Back