3-18 2G0947 - 31JAN08
Adjustments and Replacements
LOCAL PANEL AY
Prerequisites: Remove the “FRONT PANEL”.
To Remove:
1. Disconnect the CONNECTOR.
2. Remove 6 SCREWS holding the CONTROL PANEL, ELECTRONICS
BOARD and LIGHT SHIELD to the FRONT PANEL.
3. Cut the TIE WRAPS.
To Install:
To prevent damage to CABLES, install new TIE WRAPS in place of those that
were cut.
1. Reverse the steps in the removal procedure.
CONTROL PANEL
ELECTRONICS BOARD
6 SCREWS
LIGHT SHIELD
FRONT PANEL
CONNECTOR
To Next Page
Loading...
