2G0947 - 31JAN08 3-31
Adjustments and Replacements
MOTOR, DRUM DRIVE (M8)
Prerequisites: Remove the “RIGHT PANEL”.
To Remove:
1. Disconnect the CONNECTOR.
2. Disengage the EXIT DRIVE BELT from the EXIT PULLEY.
3. Loosen the 3 SCREWS so they are no longer in the STANDOFFS.
4. Remove:
• MOTOR
• 3 STANDOFFS
To Install: 1. Reverse the steps in the removal procedure.
EXIT DRIVE BELT
3 SCREWS
3 STANDOFFS
MOTOR
CONNECTOR
EXIT PULLEY
To Next Page
Loading...
