2G0947 - 31JAN08 5-67
Diagnostics
Condition Code: 21-125 or 23-125
Description
This error occurs if the FEED ROLLER NIP SENSOR (S4) does not change
from blocked to unblocked when opening or from unblocked to blocked when
closing. Most likely cause is the FEED ROLLER NIP OPEN/CLOSE MOTOR
(M1) did not turn or the SENSOR did not detect the motion. The error is cleared
when a FILM TRAY is re-inserted after being removed.
System Impact
One or more feed magazine(s) is unable to print. The spooler is still able to
accept and queue jobs and continue printing from any other available supply
tray.
User Action
1. Cover the FILM TRAY with the FILM SAVER. Remove the tray from
the IMAGER.
2. Re-insert the FILM TRAY and remove the FILM SAVER.
3. If the error persists, call for service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
1. De-energize then energize the LASER IMAGER.
2. Do the following:
3. Install a new.
Web Portal Message Log Message DICOM Message Severity
xxxxx Supply: Internal
Hardware Failure
xxxxx Supply: Feed Roller
Sensor (S4) failed to detect feed
roller open/closed position.
FILM TRANS ERR 1-Alert
Check: If an existing problem:
CONNECTORS and CABLES Seat all CONNECTORS.
FEED ROLLER NIP SENSOR Install a new SENSOR.
FEED ROLLER NIP
OPEN/CLOSE MOTOR
Install a new MOTOR (see Adjustments
and Replacements, “MOTOR, FEED
ROLLER NIP OPEN/CLOSE (M1)” on
page 3-53).
To Next Page
Loading...
