2G0947 - 31JAN08 3-9
Adjustments and Replacements
IMAGING AY - Page Start Delay, Start of Page
Adjustment Specification
Purpose: To adjust Start of Page timing to obtain a 2 mm (0.08 in.) half-tone density
border at the leading edge of the film.
Specification: A 2 mm (0.08 in.) half-tone border only is visible at the leading edge of the film.
Special Tools:
• LAPTOP COMPUTER with Microsoft INTERNET EXPLORER V 5.5
or higher
• SERVICE TOOL
• CROSSOVER CABLE, TL5568
Prerequisites None
To Check 1. Log on to the SERVICE TOOL (see Installation Instructions, “Logging
Onto the SERVICE TOOL” on page 2-4).
2. From the Service menu, select Diagnostics>DRE>Advanced Test Print.
3. In the Test Profile field, use the drop-down menu to select "Smpte8Bit".
4. Click [Run].
There should not be any printing above the "virtual notch".
To Next Page
Loading...
