3-14 2G0947 - 31JAN08
Adjustments and Replacements
BACK PANEL
Prerequisites: Remove:
• “LEFT PANEL”
• “RIGHT PANEL”
To Remove: 1. Disconnect:
• NETWORK CABLE
• POWER CORD
2. Remove 10 SCREWS.
3. Lift the BACK PANEL from the IMAGER.
To Install:
When replacing the BACK PANEL you must install an "Agency Statements"
LABEL, P/N 2G0581, on the outside of the BACK PANEL.
1. Reverse the steps in the removal procedure.
BACK PANEL
10 SCREWS
NETWORK CABLE
POWER CORD
To Next Page
Loading...
