Kodak Dryview 5800 - Software and Firmware Updates

8-4 2G0947 - 31JAN08
Additional Service Procedures
Updating the THUMB DRIVE With a New Version of System
Software
IMPORTANT:
You must energize your LAPTOP COMPUTER before inserting the THUMB
DRIVE into the USB port.
1. Energize your LAPTOP COMPUTER.
2. Insert:
• the THUMB DRIVE into the USB port on your LAPTOP
COMPUTER.
• the "Ghost" CD into the CD-ROM drive of your LAPTOP
COMPUTER.
3. Copy the software from the CD-ROM to the THUMB DRIVE.
NOTE: The old version of system software on the THUMB DRIVE will be
overwritten by the new version.
4. When the copy is complete, remove the THUMB DRIVE and CD-ROM
from your LAPTOP COMPUTER.