Kodak Dryview 5800 - Processor Drum

2G0947 - 31JAN08 3-27
Adjustments and Replacements
PROCESSOR DRUM
Prerequisites: Remove:
• “LEFT PANEL”
• “RIGHT PANEL”
To Remove:
1. Remove:
• 2 SCREWS
• RIGID DUCT
2. Cut the TIE WRAP that secures the DRUM CABLE to the PROCESSOR
CONTROL BOARD.
3. Disconnect the CONNECTOR from the PROCESSOR CONTROL
BOARD.
4. Disengage the DRUM DRIVE BELT from the DRUM PULLEY.
2 SCREWS
RIGID DUCT
CONNECTOR
DRUM PULLEY
DRUM DRIVE BELT
PROCESSOR
CONTROL BOARD
TIE WRAP
DRUM CABLE